Approval's

Specifics

1. G 10kg SWL
2. S 50kg SWL
3. Y 120kg SWL
4. P 230kg SWL
5. N 500kg SWL

Installation

1. Pass through or wrap around your required suspension.
2. Pass other end back through the easyex zip-clip.
3. At the other end again pass the wire through the easyex zip-clip in the direction of the arrow leaving 15cm of wire protruding.
4. Always conrm engagement of the easyex zip-clip on the wire by pushing the pin in the opposite the arrows indicated

Applications

1. Wrap around applications Suitable for use with a wide range of fixing brackets 
2. Cold Room Ceiling
3. Trapeze Brackets
4. Available with stainless steel wire for specialist
   applications
5. Cracked concrete, Reinforced concrete, Slagged concrete.

1. Key free release system
2. No claw back required
3. The installed nail anchor expands automatically under load, pulls the cone into the expansion clip and expands against the wall of the concrete.
4. Any spare material can be used on following projects
5. Only wire cutter required
6. Can be used as a wrap around application and with a wide range of brackets.
   Wire supplied in dispensing box – avoiding risk of wire bird nesting.
7. High tensile galvanised wire 1960 N/mm² grade 7 x 7 construction, BSEN12385 Standard.

Standard Clip

1. Drill a 6mm hole to a minimum depth of 30mm.
2. Hammer in the xing.
3. Anchor is now xed, no claw back required.
4. Unscrew the M4 locking nut and bolt until the adjustment pi is pushed back fully.
5. Pass one end of the wire through the easyex zip-clip in the direction of the arrow and draw enough wire to around your fixing point.
6. Pass the wire back through the easyex zip-clip leaving at least 15cm of wire protruding.
7. Tighten the M4 locking nut and bolt until the adjustment can no longer be moved.

Lockable clip