Features
Temperature/Pressure Ratings
Maximum temperature |
115ºC (Neoprene/EDPM) |
Maximum pressure |
16 BAR (G) |
Vacuum rating |
full vacuum (26"Hg) |
Working pressure depends on temperature and at higher temperature, the pressure ratings are reduced slightly |
Flange Drilling To :
BS Table D/E/F ANSI B16.5 Class 125/150 BS 4504/DIN 2501 or as per customer requirement
Structure
Item No. |
Part |
Material |
1 |
Body |
CR, EPDM, IIR, NBR, CSM, VITON |
2 |
Reinforce |
Nylon Cord Fabric |
3 |
Wire |
Hard Steel Wire |
4 |
Floating Flange |
Mild Steel Zinc Plated RST 37-2 |
Flanges drilling: Avaiable ANSI B 16.5, DIN 2501, JIS B 2210, BS 4504,AS 2129,ISO 7005, etc. and other standard drilling for your specifications. |
Elastomers
Neoprene – Provides excellent resistance to oxidation, ozone and sunlight ageing. Good resistance to oil.
EPDM
Good for hot and cold water service and chemicals.
Nitrile
Oil Resistant Properties.
Control Units
Tie rods and gusset plates are normally recommended and can be supplied along with the bellows.
Flanges
“EFFF" expansion joints are furnished with zinc plated steel flanges. They rotate easily on the bellow which allows for simple bolt alignment.
Warning
Control unit must be used unless piping is properly anchored. When Expansion joints are installed in pipelines or equipment carrying fluids and gases at elevated temperatures and pressure, precautions should be taken to ensure proper installation and regular inspection. Care is required to protect personnel in the event of leakage or splash.
Note : Maximum pressure rating is based on 40ºC operating temperature.
420 Britannia Road East, Unit 207,
Mississauga, ON, Canada L4Z 3L5.
Phone: 647-797-9663
© Copyright Easyflex Gobal Ventures. All rights reserved. | Developed by InnoSewa